States / Illinois / Glenview

Glenview, IL grease trap & interceptor requirements

Program run by Village of Glenview & MWRD. Hand-checked against source Last checked 2026-10-17. Report an error / rule changed

Quick answer

From the official source(s) below, last checked 2026-10-17. Rules change; verify with your city.

Need a pump-out? See 4 pumping companies serving Glenview ↓

Rules change; verify with your city. Summaries are plain-English restatements of the official source linked below; “Source says” shows the exact wording. Blank rows mean the sources we checked did not state that rule, not that there is no rule.

Required trap / interceptor type
Glenview is in the Metropolitan Water Reclamation District of Greater Chicago (MWRD) service area, so the MWRD Sewage and Waste Control Ordinance applies along with the Illinois Plumbing Code.
Illinois Plumbing Code (77 Ill. Adm. Code 890.510): commercial kitchens must have a grease interceptor with all grease-carrying fixtures directed to it; food waste disposers may not discharge into it, and water-cooled interceptors are prohibited.
MWRD Sewage and Waste Control Ordinance: discharges to MWRD sewers may not exceed 250 mg/L total fats, oils and greases (FOG).
✓ checked against source
Sizing rule
Illinois Plumbing Code minimum: the interceptor must hold at least half the liquid capacity of the connected fixtures on the same floor (60% if it sits on a floor below); fixture capacity in gallons = length × width × depth in inches ÷ 231.
✓ checked against source
Pumping / cleaning frequency
No fixed pump-out interval appears in the sources we checked; the MWRD ordinance prohibits adding physical, chemical or biological agents to grease traps or other pretreatment devices to resuspend, dissolve or emulsify grease.
✓ checked against source
Permit required?Not stated in the sources we checked
Permit & program fees
$100 annual Food Service License inspection renewal fee, plus an initial license fee.
✓ checked against source
Inspections
Food establishments need a Village Food Service License (renewed annually) and annual Village health inspections.
✓ checked against source
Record keepingNot stated in the sources we checked
Pumper / hauler approvalNot stated in the sources we checked
Reporting portalNot stated in the sources we checked
Fines & penaltiesNot stated in the sources we checked
Program contact
Glenview food service licensing: (847) 904-4305.
✓ checked against source

Sources

Grease trap pumping companies in Glenview, IL

4 companies that say on their own website they serve Glenview. Free listings are sorted A–Z. A listing is not an endorsement.

Before you book: ask for a full pump-out (not a skim) and a signed manifest for every service, and keep it on site for inspectors.

All Illinois pumpersNational directoryRun a pumping company? List it free

Size your interceptor

Use the grease interceptor sizing calculator (UPC, IPC and PDI methods), then confirm Glenview's own minimums above. Not sure how often to pump? Read how often to pump a grease trap.

Other Illinois programs

Arlington HeightsAuroraBloomingtonChampaignChicagoCiceroDecaturDes PlainesDowners GroveEdwardsvilleElginElk Grove Village

Grease rule changes, once a week

A short email when a city changes its FOG ordinance, pumping schedule, permit fees or reporting portal. Free.